Updated version: !pc8n2YSa!inZX5OXyULIxa9dgmOY7lBgWtvM8TBvAniW5-s8iTqc reopen the game and that annoying sound when shift up will be gone. NOTE: to get rid of the chime sound when you shift up, go to test mode (keyboard button P) use shiftup/down to navigate and start to make selection go to network settings and turn off nesys. make sure to delete config.bin from your directory if you have one and follow the instruction on the screens. In theory, this should work if you have an official xbox 360 controller(I was using a wireless receiver but, a wired one should work too).
Battle gear 4 tuned pc setup trial#
then for the buttons, i had to unplug the xbox controller, save the config, plug in my momo wheel, set it to combined pedals, make the wheel dead center, then do trial and error to match my steering wheel buttons to the xbox buttons (as in B0 on my wheel = B2 on the xbox and so and so) How did i do this? to get the analogs on the xbox, i had to lightly(and i mean lightly) tap the right analog stick till it was at dead zero. Note: the steering wheel does not work in the menus, use shiftup/down to navigate Incase you wondering why I dont do L trigger brake and R trigger accel is because they are the same axis. very other button is the same as version 1 except X now equals both hazzards and turbo (i ran out of buttons) Z trigger as Accel= Analog stick 1 steering and Z triggers(either one) is Accel and A button is brake. Every other button is the same as version 1 except X now equals both hazzards and turbo (i ran out of buttons) select=coin, start= start, A= turbo, B = view, Y= handbrake, X= hazzards, LB and RB are shift up and down.Ī as Accel version = Analog stick 1 steering and A button is Accel (much more natural feel). L and R pad(they both do the same) are brakes. I finally achieved the correct analog setup!ĭual Analog Version = Analog stick 1 is Steering, Analog stick 2(right side) is Accel(its a little sensitive). Once you get X, Y and rZ axis, open game4.exe and run the configuration on the screen.Įven tho i dont play it with my xbox control, I went ahead and made xbox config for you guys. (if it says Y or X axis, you did wrong, try it again) if you did it right, Analog 2 should read rZ Axis -1000.
Next to map the brake button (the hard one), you have to hold your gas pedal exactly at 50% (use the device properly as guide, it should have a reading of pedals) and step on the brake 100%.
Now step on the gas and then hit config analog 1. Next go back to the device setting (without closing ttx_config) and uncheck combine pedals and hit apply.
Battle gear 4 tuned pc setup plus#
it should map X axis -/+1000 (doesnt matter if plus or minus) Next config analog 3, have your steering wheel turn completely before you hit config. Open ttx_config and map your buttons, with your steering wheel dead center (if it not dead center, you button will default to X axis) and the pedal combined, you should be able to map your buttons without the analog defaulting. hit apply but leave the setting page open. in advance setting you should have the option to combine your pedal.
Howard, this is what i had to do get it work 100% with my logitech MOMO wheel.įirst open devices control panel on your computer and right click on your wheel opening your properties. A version 6 has been release an has fixed some of the bugs in version 5.
0 kommentar(er)
